Focus! Various standards for automatic cross-cutting line of silicon steel sheet

Source: Ruyi Transformer Equipments Manufacturer Co.,Ltd. Release time:2022-08-22 11:17:51 Author:1126

The automatic cross-cutting line of silicon steel sheet is widely used in the production line. The automatic cross-cutting line of silicon steel sheet has a high degree of automation, and the operation is simple and reliable. Do you know the various standards of the cross-cutting line? Below, I will take you to see it together.

Automatic cross-cutting line for silicon steel sheets to assess stamping quality indicators and compliance measures

In order to meet the requirements of each quality objective, the following must be met:

1) The iron core structure and iron core design are reasonable, which is convenient for active punching and shearing. , stack. Try not to wear the screw holes;

2) Try to use ancestral models and ancestral production lines for production;

3) The coils or sheets should be stacked correctly, and should be handled with care when handling and hoisting, to avoid scratching, smashing, meandering or breaking the head;

4) The blanked plate must be flat and uniform, and anti-rust paint should be sprayed on the blade;

5) When the burr is too high, it must be adjusted in real time, the gap between the molds, or regrind, and the molds must be replaced. Once the burrs and large films are processed, the company must stop pressing or use the rest to remove hair;

6) Generally, the bending parts must be leveled and must not be transferred to the next process;

7) Fluctuations should be adjusted or eliminated for paper flatness, radius, during or before slitting. Inability to correct these problems at the processing facility;

8) Carefully adjust the processing equipment and molds, and make the dimensional accuracy and burr within the scope of quality control specifications;

9) Pay attention to the purpose of rolling marks when cutting paper;

10) When pre-stacking, the film must be strictly selected, and then the unqualified film must be selected.

Automatic cross-cutting line for silicon steel sheets to assess stamping quality indicators and compliance measures

In order to meet the requirements of each quality objective, the following must be met:

1) The iron core structure and iron core design are reasonable, which is convenient for active punching and shearing. , stack. Try not to wear the screw holes;

2) Try to use ancestral models and ancestral production lines for production;

3) The coils or sheets should be stacked correctly, and should be handled with care when handling and hoisting, to avoid scratching, smashing, meandering or breaking the head;

4) The blanked plate must be flat and uniform, and anti-rust paint should be sprayed on the blade;

5) When the burr is too high, it must be adjusted in real time, the gap between the molds, or regrind, and the molds must be replaced. Once the burrs and large films are processed, the company must stop pressing or use the rest to remove hair;

6) Generally, the bending parts must be leveled and must not be transferred to the next process;

7) Fluctuations should be adjusted or eliminated for paper flatness, radius, during or before slitting. These problems cannot be corrected at the processing facility; 8) Carefully adjust the processing equipment and molds, so that the dimensional accuracy and burrs are within the scope of quality control specifications;

9) Pay attention to the purpose of rolling marks when cutting paper;

10) When pre-stacking, the film must be strictly selected, and then the unqualified film must be selected.

The above are some of the standards for the automatic cross-cutting line for silicon steel sheets that the editor has summarized for you. It will be beneficial to your production if you get as much. If you have any needs in the later stage, please consult Jiangyin Ruyi Technology Development Co., Ltd.